2015-05-14 Featuring ac motor products

Featuring its high quality and excellent performanceHelical Gear Reducer Manufacturer Gear Reducer is one of our main products Check oiling case first aluminium foil determine whether there is oil and keep oil at more than half of the oil level gauge Installed in ventilated temperature 0 C ~ 40 C environment Unplug refuel before using the cover latch Turbine reducer connection 1 Coupling link into force or the output shaft the need to also make two really fixed axis parallel to the positive locking base 2 When the input shaft is hollow adding the appropriate grease to avoid excessive wear and aperture issue abnormal sound the aluminium foil shaft can be coated with anti-rust paint to avoid rust 3 sprocket connected to the output shaft of the pulley with H7 tolerance must be used to avoid sending a different sound to the shaft surface damage Turbine gear lubricant Should be injected into the turbine gear 1 Before running lubricating oil to the top of the center mark 2 After the first 100 hours of use internal wash put new oil after an oil change once every 2500 hours 3 Insufficient grease may cause rapid wear and reduce the efficiency of the turbine too much may lead to leakage Lubricating oil to the top of the center can be marked Matters turbine installation gearhead 1 turbine gear aluminium foil installed to take into account its axis poles and other factors 2 turbine reducer points single-stage two-stage 3 Most of the reducer output shaft and the input shaft has but there are a small part of the hollow shaft such as the most common BAKDO turbine is hollow shaft gear type 4 Another case is that there is an input shaft but no gear output shaft such BAKO turbine reducer Of course depends on the user’s specific needs may be 5 turbine gearbox input shaft and the motor is recommended when using elastic coupling link while the output gear coupling is used along as well as other non-rigid coupling 6 Enter the output axis and the axis of the axis of the coupling part must be kept concentricity the error does not exceed the rating of the coupling range used 7 After a good grasp of these cases the next is the degree of operating flexibility to detect reducer detection method is very simple to rotate by hand several times repeated must be ,ac motor